Get Dynamics CRM layoutXml used in View from DevTools

Most times when you want to use AddCustomView() method to a Dynamics 365 control, you need to pass layoutXml to the method that will show the view you define.
fromCOde

There’s an easier trick than writing this up.

Select your View

Assuming, you have an Advanced Find view open in the window which you want as a layoutXml of, on the same, press F12 to open Dev Tools. Select the selector.
selector

And on the Advanced Find window, select Body section
andSelectBody
Click on it, and the par will be selected in the Console of the Dev Tools.

Once this is available, search for layoutXml and cycle through the results to go to the last result.
selectFromConsole

select the “value” part. That is your layoutXml. Hope this helps.


Share Story :


SEARCH :

FOLLOW CLOUDFRONTS BLOG :

FOLLOW CLOUDFRONTS BLOG :

Enter your email address to follow this blog and receive notifications of new posts by email.

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close