Time Out and Retry Policy in Power Automate
Introduction:
While using Power Automate actions, you may need to retry or set timeout for your actions.
Solution:
For Create, Update, Delete, Send HTTP request, Do Until Actions, simply go to Settings
In Settings, you will find Timeout and Retry Policy options.
Time Out: For the duration specified, the action will wait and then time out. Here P1D means 1day.
For minute- specify P1M and S for Seconds.
Retry: You can set the retry policy.
There are 4 types:
- Default- The default is an exponential interval policy set to retry 4 times.
- None- Do not Retry
- Fixed Internal- Count( No of times to retry), Interval( time between retry).
4. Exponential Interval- Count(No of times to retry), Interval(Time between retry), Minimum and Maximum Interval (the Retry will happen exponentially[Increase or decrease] between the specified intervals)
Eg: If Interval is 1H and minimum Interval is set to 1M- it will decrease exponentially till it reaches 1M.
